Multi-Purpose Oscillating Tool Operator’s Manual Outil oscillant à usages multiples Manuel d’utilisation Herramienta oscilante multiuso Manual del Operario GMT15A
English Multi-Purpose Oscillating Tool Operator’s Manual 1.5 AMP Specifications: • • • Model: GMT15A Rated Input: 120V~AC, 60HZ, 1.5A No Load Speed: 21,000/min (OPM) Includes: Oscillating Tool, Hook & Loop Sanding Pad, Assorted Sandpaper, Rigid Scraper Blade, 1-3/16" (30mm) E-Cut (Flush Cut) Saw Blade, 3” Wood & Drywall Saw Blade, and Wrench Warning: To reduce the risk of injury, user must read and understand this operator’s manual before operating this tool.
English Warning: READ AND UNDERSTAND ALL WARNINGS, CAUTIONS AND OPERATING INSTRUCTIONS BEFORE USING THIS EQUIPMENT. Failure to follow all instructions listed below may result in electric shock, fire and/or serious personal injury. SAVE THESE INSTRUCTIONS WORK AREA SAFETY: • Keep your work area clean and well lit. Cluttered benches and dark areas invite accidents. • Do not operate power tools in explosive atmospheres, such as in the presence of flammable liquids, gases, or dust.
English • Do not force the power tool. The tool will perform the job better and safer at the feed rate for which it is designed. Forcing the tool could possibly damage the tool and may result in personal injury. • Use the correct power tool for the job. Don’t force the tool or attachment to do a job for which it is not designed. • Do not use tool if switch does not turn it on or off.
English EXTENSION CORDS Grounded tools require a three wire extension cord. Double insulated tools can use either a two or three wire extension cord. As the distance from the power supply outlet increases, you must use a heavier gauge extension cord. Using extension cords with inadequately sized wire causes a serious drop in voltage, resulting in loss of power and possible tool damage. Refer to the table shown below to determine the required minimum wire size.
English Warning: USE OF THIS TOOL CAN GENERATE AND DISBURSE DUST OR OTHER AIRBORNE PARTICLES, INCLUDING WOOD DUST, CRYSTALLINE SILICA DUST AND ASBESTOS. Direct particles away from face and body. Always operate tool in a well-ventilated area and provide for proper dust removal. Use dust collection system wherever possible. Exposure to the dust may cause serious and permanent respiratory or other injury, including silicosis (a serious lung disease), cancer, and death.
English ASSEMBLY AND ADJUSTMENTS Warning: Always be sure that the tool is switched off and unplugged before adjusting, adding accessories, or checking a function on the tool To install the saw blade or scraper blade 1. Loosen and remove the cap screw (a) and large blade washer from the shaft flange using Allen wrench provided. (FIG 1) 2. Place the accessory over the shaft flange (b). The shaft flange of this tool comes with a 4-pin design.
English APPLICATIONS NOTE: This tool must be used only with GENESIS oscillating tool accessories. See Accessories Chart for details. This multi-purpose oscillating tool is intended for cutting and sanding wood, plastic, plaster and non-ferrous metals. It is especially suitable for cutting in tight spaces and for flush cutting. Following are a few typical uses. Cutting: Use a flush cutting saw blade (or “e-cut blade”) for making precise cuts in tight areas, close to edges or flush to a surface.
English ACCESSORIES NOTE: This tool must be used only with GENESIS oscillating tool accessories. Model Picture Description Recommended Application Flush Cut Saw Blade Assortment Cutting and flush cuts in Wood, Plastic, Drywall and Pack, other soft materials. GAMT301 Size: 3/8" (10mm), For example: Size: 3/4" (20mm), Size: 1-3/16" (30mm) -Flush cutting door jamb or base molding. -Cut-outs in furniture for cable connections.
Notes
Notes Notes
Richpower Industries, Inc. 736 Hampton Road Williamston, SC USA www.richpowerinc.
