Installation Guide
S
S
t
t
a
a
r
r
t
t
-
-
U
U
p
p
P
P
r
r
o
o
c
c
e
e
d
d
u
u
r
r
e
e
s
s
The following are the start-up procedures for GenerLink. For generator start-up
procedures, please refer to the generator manufacturer owner’s manual.
STEP 1: Turn off all of the circuit breakers in your breaker panel. (See Diagram 2)
Diagram 2
STEP 2: Move your generator into position to be
connected to GenerLink. Using the GenerLok™ power
cord, insert the four-blade plug on the connecting cord
into the 20-, 30- or 50-amp, 120/240-volt outlet on the generator.
Do not attempt to connect
your generator
using a connection
cord
that is
n
o
t
fitted with
GenerLok.
Do not attempt to connect to a
three-blade
ge
n
e
r
a
t
o
r
o
u
t
l
e
t
or
one
rated higher
than 50-amps. (See the
GenerLok
P
owe
r
Cord
sec
t
i
o
n
of this
m
a
nu
a
l
)
STEP 3: To plug the GenerLok power cord into GenerLink, first locate the ‘thumb
guide’ on the GenerLok connector. Align the ‘thumb guide’ with the front of the
GenerLink receptacle. Insert the connector, there will be a snapping sound when the
connector locks in place. (See Diagram 3)
Note: GenerLok cannot be connected successfully:
- if the thumb guide is not correctly aligned with the GenerLink receptacle or
- if the connector does not lock in place (no snapping sound)
Diagram 3
G
e
n
e
rL
i
nk
R
e
c
ep
ta
c
l
e
G
e
n
e
rL
o
k
C
o
nn
e
c
t
o
r
T
hu
m
b
G
u
i
de