Installation Guide

ManualsBrandsGeneric ManualsAppearance Boards & Planks1 in. x 6 in. x 8 ft. PVC Beaded Ceiling/Wall Board

INSTALLATION INSTRUCTIONS

BlueLinx PVC Trim Products (“Trim”) is an exterior decorative trim and not designed to

be used in structural, load-bearing applications. These Installation Guidelines are a

general resource in standard installation techniques.

Safety

 Cut Trim in an open, ventilated area.

 Always wear safety glasses and a face/dust mask when cutting

Trim.

 Follow all manufacturer’s recommendations and warnings.

Product Storage

Trim is more flexible than wood, so it may conform to uneven surfaces,

particularly in warm weather. Store Trim away from direct sunlight and high

temperatures. Store Trim off the ground on a flat, level surface. Once opened, protect

the Trim from dirt and debris. If it does get dirty, clean after installation. Clean Trim

with a soft bristle brush and mild soap and water.

Cutting

Trim can be cut using standard woodworking power tools. Do not use fine-tooth

metal-cutting blades. Using too thin of a blade can cause heat build up in the Trim. For

best results use a 32 – tooth (or higher) blade designed for woodworking. To maintain a

smooth edge, support the Trim across the entire length when it is being cut. If you get a

rough edge, rasp and sand the Trim to restore a smooth edge.

Drilling

Although you can drill with standard woodworking drill bits, do not use bits made

for rigid PVC. Avoid heat buildup from excessive friction, and remove the shavings

from the drill hole frequently.

Summary of content (5 pages)

PAGE 1
INSTALLATION INSTRUCTIONS BlueLinx PVC Trim Products (“Trim”) is an exterior decorative trim and not designed to be used in structural, load-bearing applications. These Installation Guidelines are a general resource in standard installation techniques. Safety    Cut Trim in an open, ventilated area. Always wear safety glasses and a face/dust mask when cutting Trim. Follow all manufacturer’s recommendations and warnings.
PAGE 2
Routing For crisp clean edges, use a sharp carbide-tipped bit on a router. It is recommended that you mount the router on a table as hand held models may be difficult to control. Edge Finishing Trim can be finished by machine edging or sanding. A smoother edge can be obtained by applying spackle, sanding or painting. Do not allow excess frictional heat to build up when edging or sanding. Bending Trim can be bent by using convection air circulation ovens, strip heater or radiant heaters.
PAGE 3
   Use an adhesive designed for use with cellular PVC trim to bond all scarf and miter joints. To allow sufficient time for a full cure, joints should be fastened through the joint or fastened on each side of the joint. Adhesives alone are not recommended for fastening Trim. Bonding and Adhesives Trim can be bonded to a variety of substrates as well as itself. Never use adhesives alone to fasten Trim to a substrate. Always follow manufacturer’s guidelines, and keep all material clean and dry.
PAGE 4
    Allow 1/8 inch per 18 feet of Trim for expansion and contraction. Allow this space at both ends of a long run. Proper fastening along the entire length will minimize expansion and contraction of the Trim. Glued joints between trim pieces will help eliminate separation. To minimize seams, use scarf joints – which also minimize expansion and contraction of Trim. Window and Door Trim Cladding and Trim are not watertight barriers.
PAGE 5
Corners   For butted joints, use a fastener through the butt every 16 inches. Let the corner cure, and install as you would a wood corner. For mitered joints, assemble the corner before installing it. Apply PVC adhesive to the length of the miter and fasten the corner pieces together. Rakes, Fascia and Bandboards For long runs, a scarf joint is highly recommended for appearance. Gluing the joints between the trim pieces will help eliminate separation caused by expansion and contraction.