Installation Sheet

1
Installation Instructions for
Aubry 2 Light Oval Pendant
1.0
TP1082
Pendant
T 1082P
GP I :ENERAL RODUCT NFORMATION
These fixtures are intended to be installed utilizing NEC compliant junction
boxes.
This product is safety listed for damp locations.
Incandescent lamps may be dimmed with a standard incandescent dimmer.
LED lamps may be dimmed with a LED dimmer. Consult lamp manufacturer
for additional information.
This instruction shows a typical installation.
1
2
1A
3
CAUTION RISK OF FIRE-
This product must be installed in accordance with the
applicable installation code by a person familiar with the
construction and operation of the product and the hazards
involved.
Use minimum 90°c supply conductors.
Secure the mounting plate to the junction box.
Install a quick link onto the end of the chain and fixture loop. Determine the wanted height of the fixture and remove a portion of
the chain by opening a link and removing it from the top. Then install the other quick link onto the chain and canopy loop.
Weave the cord through the chain and canopy and out of the junction box. Trim the cord leaving enough to make electrical
connections.
Connect the fixture to a suitable ground in accordance to local electrical codes.
Connect the white fixture wire (square and/or rigid) to the neutral power line wire with a wire nut.
Connect the black fixture wire (round and/or smooth) to the hot power line wire with a wire nut.
Neatly place all the wires into the junction box, place the canopy onto the ceiling, and secure it in place with the provided canopy
screws.
Screw the lamp into the socket. Refer to the label on the socket for Max Wattage information.
Gently Lift shade into the fixture, and secure in place with the provided screws.
4
5
6
7
8
9
6
LAMP
SHADE
CANOPY
MOUNTING PLATE
JUNCTION BOX
8
5
9
CHAIN
QUICK LINK
QUICK LINK
CANOPY SCREW
FIXTURE LOOP
FIXTURE
SOCKET
CANOPY LOOP
7
2
SHADE SCREW
1
3