Installation Sheet

1
Installation Instructions for
Logan 2 Light Flush Mount
1.0
TF1002
Ceiling
TF1002
GP I :ENERAL RODUCT NFORMATION
These fixtures are intended to be installed utilizing NEC compliant junction
boxes.
This product is safety listed for damp locations.
Incandescent lamps may be dimmed with a standard incandescent dimmer.
LED lamps may be dimmed with a LED dimmer. Consult lamp manufacturer
for additional information.
This instruction shows a typical installation.
1
2
1A
3
CAUTION RISK OF FIRE-
This product must be installed in accordance with the
applicable installation code by a person familiar with the
construction and operation of the product and the hazards
involved.
Use minimum 90°c supply conductors.
Secure the mounting plate to the junction box.
Connect the fixture to a suitable ground in accordance to local electrical codes.
Connect the white fixture wire (square and/or rigid) to the neutral power line wire with a wire nut.
Connect the black fixture wire (round and/or smooth) to the hot power line wire with a wire nut.
Neatly place all the wires into the junction box, place the fixture base and washer onto the threaded nipple, and secure them in
place by screwing the hex nut onto the nipple followed by the cap nut.
Screw the lamps into the sockets. Refer to the label on the socket for Max Wattage Information.
Insert the shade into the cage.
Align the holes in the cage with the tabs and secure them together using the cage screws.
4
5
6
JUNCTION BOX
4
3
LAMP
FIXTURE BASE
MOUNTING PLATE
WASHER,
HEX NUT, &
CAP NUT
SHADE
CAGE SCREW
CAGE
7
8
8
7
MOUNTING STUD
6
5
TAB
8