Installation Sheet

1
CAUTION RISK OF FIRE-
This product must be installed in accordance with the applicable
installation code by a person familiar with the construction and
operation of the product and the hazards involved.
Use minimum 90°c supply conductors.
GP I :ENERAL RODUCT NFORMATION
These fixtures are intended to be installed utilizing compliant junction boxes.NEC
This product is safety listed for wet locations.
Incandescent lamps may be dimmed with a standard incandescent dimmer.
LED LEDlamps may be dimmed with a dimmer. Consult lamp manufacturer for
additional information.
This instruction shows a typical installation.
SAVE THESE INSTRUCTIONS!
OUTDOOR
©2020 Visual Comfort & Co., L.L.C. All rights reserved. The Visual Comfort & Co. logo is a registered trademark of Visual Comfort & Co.
Visual Comfort & Co. reserves the right to change specifications for product improvements without notification.
7400 Linder Ave., Skokie, IL 60077
T 847.410.4400 | F 847.410.4500
www.generationlighting.com
Installation Instructions for
1.0
OL15400-OL15401-OL15402-OL15403-OL15404
O 15400, O 15401, O 15402, O 15403, OL15404LLLL
1A
13
Warren Outdoor Wall
For Models Ol15401, OL15402, OL15403, OL15404 Only: Temporarily install the mounting plate to the junction box and mark the anchor
hole locations through the mounting plate holes. Remove the mounting plate.
For Models Ol15401, OL15402, OL15403, OL15404 Only: Drill appropriate sized holes at the marked locations and install the anchors.
Secure the mounting plate to the junction box.
For Models Ol15401, OL15402, OL15403, OL15404 Only: Screw the anchor screws into the anchors.
Attach the fixture arm to the fixture base and fixture loop with the provided screws.
Slide glass panels into the lower cover and secure each panel with clips.
Connect the fixture to a suitable ground in accordance with local electrical codes.
Connect the white fixture wire to the neutral power line wire with a wire nut.
Connect the black fixture wire to the hot power line wire with a wire nut.
Mount the fixture base onto the mounting plate and secure it with the fixture screws.
Screw the lamps into the sockets. Refer to the label on the socket for Max Wattage Information.
Install the lower cover to the top cover by using the cover screws.
For wet locations, caulk around the base of the fixture with waterproof construction sealant.
1
2
3
4
5
6
7
8
9
10
LAMP
11
FIXTURE
SCREW
9
MOUNTING
PLATE
9
8
7
3
5
TOP COVER
JUNCTION BOX
12
12
GLASS CLIP
GLASS PANEL
COVER SCREW
FIXTURE LOOP
FIXTURE ARM
FIXTURE
BASE
LOWER COVER
7
8
9
10
1011
1012
1013
5