Instructions / Assembly

GENERAL INSTALLATION
Before you begin installing the fan, Switch
power off at Service panel and lock
service disconnecting means to prevent
power from being switched on
accidentally. When the service
disconnecting means cannot be locked,
securely fasten a warning device, such
as a tag, to the service panel.
Remove the set screws from switch
housing. Keep screws.
Switch housing may be different than
shown.
Unplug (If wiring with quick connectors)
and remove the switch housing from fan.
Remove tap from bottom of switch housing. Remove the hex nut and lock washer from
the light fixture. Keep parts.
Thread the lead wires from the light fixture
through central hole in switch housing
Place the lock washer and hex nut removed
in the installation step 5 over the lead wires
from the light fixture and tighten securely
with the thread rod of the light fixture.
Connect white wire from light fixture
with white wire from fan and then
connect black (or blue) wire from light
fixture with blue (or black) wire from
fan.
Attached the light fixture with switch
housing onto the top cover of switch
housing and reinstall the set screws
removed in the installation step 2.
ON
OFF
ON
OFF
Switch housing, plugs may be
different than shown
Switch housing
Tap
Hex nut
Lock washer
Switch housing
Hex nut
Lock washer
Light fixture
3
1
2 3
4
5
6
7 8
9
10/2021
© 2021 Monte Carlo Fan Collections