Installation Guide

1
Installation Instructions for
Secure the mounting plate to the junction box.
Connect the fixture ground wire to a suitable ground in accordance to local electrical codes.
Connect the white fixture wire to the neutral power line wire with a wire nut.
Connect the black fixture wire to the hot power line wire with a wire nut.
Properly place all wires and wire nut connections into the junction box/fixture base, mount the fixture onto the mounting plate,
and secure it in place with the set screw using the Allen wrench.
Place the shade over the socket, then secure it in place by screwing the collar nut onto the socket. Repeat for remaining shades.
Screw the lamp(s) into the socket(s). Refer to the label on the socket for Max Wattage Information.
Install the finial to the bottom of the fixture and secure it in place using the bolt. Repeat for remaining finials.
1
2
3
4
5
Robert Wall
6
1A
7
Wall
CAUTION RISK OF FIRE-
This product must be installed in accordance with the
applicable installation code by a person familiar with the
construction and operation of the product and the hazards
involved.
Use minimum 90°c supply conductors.
GP I :ENERAL RODUCT NFORMATION
These fixtures are intended to be installed utilizing NEC compliant junction
boxes.
This product is safety listed for damp locations.
Incandescent lamps may be dimmed with a standard incandescent dimmer.
LED lamps may be dimmed with a LED dimmer. Consult lamp manufacturer
for additional information.
JUNCTION BOX
8
4
SET SCREW
5
BOLT
1.0
LV1032
LV1032, LV1043, LW1041
3
LAMP
SOCKET
7
FINIAL
SHADE
COLLAR NUT
MOUNTING PLATE
ALLEN WRENCH
6
8