Installation Guide

1
Installation Instructions for
Hazel Pendant
1.0
LP1001
Pendant
LP1001, LP1011
GP I :ENERAL RODUCT NFORMATION
These fixtures are intended to be installed utilizing NEC compliant junction
boxes.
This product is safety listed for damp locations.
Incandescent lamps may be dimmed with a standard incandescent dimmer.
LED lamps may be dimmed with a LED dimmer. Consult lamp manufacturer
for additional information.
1
2
1A
3
CAUTION RISK OF FIRE-
This product must be installed in accordance with the
applicable installation code by a person familiar with the
construction and operation of the product and the hazards
involved.
Use minimum 90°c supply conductors.
4
5
6
7
8
Install the glass to the bracket, letting the socket loose over the glass, and secure the glass in place by using the knurled cap screws,
rubber washers and ball cap nut as shown. Insert the socket into the glass and secure it in place by screwing the spacer (for LP1001 only)
and the collar nut on the socket.
Screw the half ball to the stem which will be on top.
Determine the wanted height or look of the fixture with the provided stems, then assemble them by screwing them together.
Feed the fixture wires through the stem assembly, then screw the stem assembly to the socket assembly.
Feed the fixture wires through the collar nut, canopy, and the half ball assembly, then screw it onto the stem assembly.
Align and secure the mounting plate to the junction box, then slide the half ball assembly onto the mounting plate.
Connect the fixture to a suitable ground in accordance to local electrical codes.
Connect the white fixture wire (square and/or rigid) to the neutral power line wire with a wire nut.
Connect the black fixture wire (round and/or smooth) to the hot power line wire with a wire nut.
Neatly place all the wires into the junction box, place the canopy onto the mounting plate, and secure it in place by screwing the collar
nut tightly onto the mounting plate.
Screw the lamp into the socket. Refer to the label on the socket for max wattage information.
9
10
11
9
8
MOUNTING PLATE
JUNCTION BOX
STEM
HALF BALL
2
SHADE
STEM ASSEMBLY
1
COLLAR NUT
(FOR LP1001 ONLY)
CAP NUT
RUBBER WASHERS
KNURLED CAP SCREW
BRACKET
1
COLLAR NUT
(FOR LP1011 ONLY)
LAMP
1
SPACER (FOR LP1001 ONLY)
CANOPY
COLLAR NUT
HALF BALL
ASSEMBLY