Installation Sheet

1A
Install the Fixture
2
Temporarily install the mounting plate to the junction box.
Mark the anchor locations through the holes on the mounting plate. Remove the mounting plate.
Drill appropriate sized holes at the marked locations and install the anchors.
Secure the mounting plate to the junction box and screw the anchors screws into the anchors.
Connect the fixture to a suitable ground in accordance with local electrical codes.
Connect the white fixture wire to the neutral power line wire with a wire nut.
Connect the black fixture wire to the hot power line wire with a wire nut.
Neatly tuck the wiring into the junction box, place the fixture base onto the mounting plate, and secure it in place with fixture screws.
Install the candle tubes by sliding them over the sockets.
Screw the lamps into the sockets. Refer to the label on the socket for max wattage information.
1
2
3
4
5
6
7
MOUNTING PLATE
7
6
JUNCTION BOX
LAMP
4
ANCHOR
8
8
ANCHOR SCREW
CANDLE TUBE
10
5
9
10
FIXTURE BASE
FIXTURE
SCREW
8
4
33
9