Installation Sheet

1.0

HADLEY-LINEARCHANDELIER

LC1165

Installation Instructions for

Hadley Chandelier

CHANDELIER

SAVE THESE INSTRUCTIONS!

CAUTION RISK OF FIRE-

This product must be installed in accordance with the applicable

installation code by a person familiar with the construction and

operation of the product and the hazards involved.

Use minimum 90°c supply conductors.

GP I :ENERAL RODUCT NFORMATION

These fixtures are intended to be installed utilizing compliant junctionNEC

boxes.

This product is safety listed for damp locations.

Incandescent version may be dimmed with a standard incandescent dimmer.

LED LEDversion may be dimmed with a dimmer. Consult lamp manufacturer

for additional information.

This instruction shows a typical installation.

UPPER FRAME

JOINT

ALLEN WRENCH

& SET SCREW

CENTER FRAME

ALLEN WRENCH

& ALLEN SCREW

1B 1B

Assemble the Frame

Assemble the Frame:

A) Insert the side frame (make sure the stitches on the leather face the center of the fixture) into the upper frame and secure them with the set

screws using the small provided Allen wrench.

B) Install the joints to the ends of the side frames and secure them together with the set screws using the provided small Allen wrench.

C) Install the center frames (make sure the drain holes, if any, are facing up) onto side frame joints with fixture screws using the large provided

Allen wrench. Adjust the frames if needed.

UPPER FRAME

DRAIN

HOLE

DRAIN

HOLE

JOINT

Visual Comfort & Co. reserves the right to change specifications for product improvements without notification.

7400 Linder Ave., Skokie, IL 60077

T 847.410.4400 | F 847.410.4500

www.generationlighting.com

PAGE 1
HADLEY-LINEARCHANDELIER Installation Instructions for Hadley Chandelier LC1165 1.0 CHANDELIER GENERAL PRODUCT INFORMATION: CAUTION - RISK OF FIRE This product must be installed in accordance with the applicable installation code by a person familiar with the construction and operation of the product and the hazards involved. These fixtures are intended to be installed utilizing NEC compliant junction boxes. This product is safety listed for damp locations. Use minimum 90°c supply conductors.
PAGE 2
Install the Fixture 2A 13 ANCHOR 3 12 11 3 MOUNTING PLATE ANCHOR SCREW 4 4 CANOPY CANOPY LOOP 14 CANOPY SCREW 14 QUICK LINK CHAIN 6 FIXTURE LOOP 6 RUBBER WASHER FRAME ASSEMBLY 16 STEM 15 LAMP CANDLE TUBE SOCKET 5 5 SOCKET ASSEMBLY 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 Temporarily install the mounting plate to the junction box. Mark the anchor locations through the holes on the mounting plate. Remove the mounting plate.