Installation Guide

1
Installation Instructions for
Nodes Pendant
1.0
KP1001-KP1011
Pendant
KP1001, KP1011
GP I :ENERAL RODUCT NFORMATION
These fixtures are intended to be installed utilizing NEC compliant junction
boxes.
This product is safety listed for damp locations.
Incandescent lamps may be dimmed with a standard incandescent dimmer.
LED lamps may be dimmed with a LED dimmer. Consult lamp manufacturer
for additional information.
This instruction shows a typical installation.
1
2
1A
3
CAUTION RISK OF FIRE-
This product must be installed in accordance with the
applicable installation code by a person familiar with the
construction and operation of the product and the hazards
involved.
Use minimum 90°c supply conductors.
Secure the mounting plate to the junction box.
Determine the wanted height of the fixture by feeding the cord through the canopy and moving the cord up or down. Place the
cord in between the two cord clips and secure it in place using the clip screws.
Trim the cord leaving enough for electrical connections. From the end of the cord, strip the insulation 4” and then strip the end of
the wires. Make sure not to nick the inner wires.Note:
Connect the fixture to a suitable ground in accordance to local electrical codes.
Connect the white fixture wire (square and/or rigid) to the neutral power line wire with a wire nut.
Connect the black fixture wire (round and/or smooth) to the hot power line wire with a wire nut.
Neatly place all the wires into the junction box, place the fixture base onto the mounting plate, and secure it place using the
fixture screws.
Screw the plate onto the socket.
Install the lamps by pushing the lamp pins completely into the socket holes. Refer to the label on the socket for Max Wattage
Information.
Install the shade by screwing it onto the socket.
4
5
6
7
8
CANOPY SCREW
MOUNTING PLATE
CANOPY
PLATE
10
7
SHADE
CORD
CORD CLIP
CLIP SCREW
2
3
CORD
6
JUNCTION BOX
5
7
LAMP
9
8
1
9
10