Installation Sheet

1
Installation Instructions for
Nodes Semi-Flush Mount
1.0
KF1034
Ceiling
KF1034
GP I :ENERAL RODUCT NFORMATION
These fixtures are intended to be installed utilizing NEC compliant junction
boxes.
This product is safety listed for damp locations.
Incandescent lamps may be dimmed with a standard incandescent dimmer.
LED lamps may be dimmed with a LED dimmer. Consult lamp manufacturer
for additional information.
This instruction shows a typical installation.
1
2
1A
3
CAUTION RISK OF FIRE-
This product must be installed in accordance with the
applicable installation code by a person familiar with the
construction and operation of the product and the hazards
involved.
Use minimum 90°c supply conductors.
Secure the mounting plate to the junction box.
Connect the fixture to a suitable ground in accordance to local electrical codes.
Connect the white fixture wire (square and/or rigid) to the neutral power line wire with a wire nut.
Connect the black fixture wire (round and/or smooth) to the hot power line wire with a wire nut.
Neatly place all the wires into the junction box, place the canopy onto the ceiling, and secure it in place with the provided canopy
screws.
Install the plate over the socket and install the lamp by inserting it into the socket, Refer to the label on the socket for Max
Wattage Information.
Carefully screw the shade onto the socket. Do not over tighten. Make sure the shade is installed correctly before releasing.
Repeat steps 6 and 7 for remaining sockets.
4
5
6
7
SHADE
MOUNTING PLATE
JUNCTION BOX
7
FIXTURE BASE
SOCKET
3
4
PLATE
CANOPY SCREW
5
LAMP
6