Manualshelf

Installation Sheet

ManualsBrandsGeneration Lighting ManualsChandeliersNodes 8 Light 53" Wide Chandelier
12
1
Installation Instructions for
Nodes 8 and 12 Light Chandelier
1.1
KC1008-KC1012
Pendant
K 1008, KC1012C
GP I :ENERAL RODUCT NFORMATION
These fixtures are intended to be installed utilizing NEC compliant junction
boxes.
This product is safety listed for damp locations.
Incandescent lamps may be dimmed with a standard incandescent dimmer.
LED lamps may be dimmed with a LED dimmer. Consult lamp manufacturer
for additional information.
1
2
1A
3
CAUTION RISK OF FIRE-
This product must be installed in accordance with the
applicable installation code by a person familiar with the
construction and operation of the product and the hazards
involved.
Use minimum 90°c supply conductors.
Temporarily install the mounting plate to the junction box.
Mark the anchor hole locations through the mounting plate, then remove the mounting plate.
Drill appropriate sized holes and install the anchors.
Secure the mounting plate to the junction box and screw the anchor screws into the anchors.
Determine the wanted height of the fixture with the provided stems and assemble them by screwing them together.
Screw the nipples onto the swivels, then screw the swivel onto the stem assemblies.
Feed the cords through the stem assemblies and swivels, then screw the stem assemblies onto the fixture.
Feed the cords through the canopy and plate, then secure them onto the swivels using provided washers and hex nuts.
Connect the fixture to a suitable ground in accordance to local electrical codes.
Connect the white fixture wire (square and/or rigid) to the neutral power line wire with a wire nut.
Connect the black fixture wire (round and/or smooth) to the hot power line wire with a wire nut.
Neatly place all the wires into the junction box, place the fixture base onto the mounting plate, and secure it place using the
canopy screws.
For KC1008 Only: For KC1012 Only:Place the plate over the socket. Screw the plate onto the socket.
Install the lamps by pushing the lamp pins completely into the socket holes. Refer to the label on the socket for Max Wattage
Information.
Install the shades by screwing them onto the sockets.
4
5
6
7
8
CANOPY SCREW
MOUNTING PLATE
CANOPY
SWIVEL
11
JUNCTION BOX
10
4
9
10
ANCHOR
ANCHOR SCREW
11
12
13
14
14
13
12
CANOPY PLATE
NUT & WASHER
PLATE
SHADE
LAMP
SOCKET
15
NIPPLE
3
14
15
6
7
8
STEM

Summary of content (2 pages)