Installation Sheet

Installation Instructions for
Secure the mounting plate to the junction box. NOTE: For Model EW1001/EW1161, use a 2x4 junction box.
Connect the fixture to a suitable ground in accordance with local electrical codes.
Connect the white fixture wire to the neutral power line wire with a wire nut.
Connect the black fixture wire to the hot power line wire with a wire nut.
Mount the fixture base onto the mounting plate and secure it with the fixture screws.
Screw the lamp(s) into the socket(s). Refer to the label on the socket for max wattage information.
OPTIONAL: Install the shade by carefully placing it over the socket and onto the shade base. Repeat for remaining shades if necessary.
1
2
3
1A
4
5
Brianna Wall
1.1
EW1001-EW1002
E 1001, E 1002, E 1161WWW
JUNCTION BOX
(FOR MODEL EW1002)
MOUNTING
PLATE
4
6
SHADE (OPTIONAL)
3
7
FIXTURE SCREW
LAMP
SOCKET
6
5
5
7
JUNCTION BOX
(FOR MODEL EW1001/EW1161)
STANDARD
JUNCTION BOX
2" x 4"
JUNCTION BOX
GP I :ENERAL RODUCT NFORMATION
These fixtures are intended to be installed utilizing NEC compliant junction
boxes. For Model EW1001/EW1161, use 2”x4” junction box.
This product is safety listed for damp locations.
This instruction shows a typical installation.
WALL
CAUTION RISK OF FIRE-
This product must be installed in accordance with the applicable
installation code by a person familiar with the construction and
operation of the product and the hazards involved.
Use minimum 90°c supply conductors.
SAVE THESE INSTRUCTIONS!
©2022 Visual Comfort & Co., L.L.C. All rights reserved. The Visual Comfort & Co. logo is a registered trademark of Visual Comfort & Co.
Visual Comfort & Co. reserves the right to change specifications for product improvements without notification.
7400 Linder Ave., Skokie, IL 60077
T 847.410.4400 | F 847.410.4500
www.generationlighting.com