Manualshelf

Installation Guide

ManualsBrandsGeneration Lighting ManualsLightingSimon 1-Light Matte Black Wall Sconce with Burnished Brass Swivel Handle
12
1
Installation Instructions for
Temporarily install the mounting plate to the junction box.
Mark the anchor hole locations through the mounting plate, then remove the mounting plate.
Drill appropriate sized holes and install the anchors.
Secure the mounting plate to the junction box.
Screw the anchor screws into the anchors.
Connect the fixture ground wire to a suitable ground in accordance to local electrical codes.
Connect the white fixture wire to the neutral power line wire with a wire nut.
Connect the black fixture wire to the hot power line wire with a wire nut.
Mount the fixture onto the mounting plate and secure it in place with the fixture screws.
Screw the lamp into the socket. Refer to the label on the socket for Max Wattage Information.
Install the handle by screwing it onto the arm.
Adjust the arm by moving the handle left or right until the desired position is reached. Make sure to not rotate the arms past
the indicated point (see figure 1).
1
2
3
4
5
1.0
EW1041
EW1041
6
7
8
GP I :ENERAL RODUCT NFORMATION
These fixtures are intended to be installed utilizing compliant junctionNEC
boxes.
This product is safety listed for damp locations.
Incandescent lamps may be dimmed with a standard incandescent dimmer.
LED LEDlamps may be dimmed with a dimmer. Consult lamp manufacturer for
additional information.
1A
JUNCTION BOX
9
10
11
Simon 1 Light Wall
Wall
CAUTION RISK OF FIRE-
This product must be installed in accordance with the
applicable installation code by a person familiar with the
construction and operation of the product and the hazards
involved.
Use minimum 90°c supply conductors.
MOUNTING
PLATE
7
8
HANDLE
9
ANCHOR
FIXTURE
SCREW
ANCHOR
SCREW
ARM
LAMP
3
10
DO NOT ROTATE
ARMS BEYOND
THIS LINE
DO NOT ROTATE
ARMS BEYOND
THIS LINE
5
11
12
FIGURE 1

Summary of content (2 pages)