Installation Guide

Installation Instructions for

Hopton Floor Lamp

1.0

ET1212

Portable

GP I :ENERAL RODUCT NFORMATION

This product is safety listed for dry locations only.

This instruction shows a typical installation.

IMPORTANT SAFETY INSTRUCTIONS

This portable lamp has a polarized plug (one blade is wider

than the other) as a safety feature to reduce the risk of

electric shock.This plug will fit in a polarized outlet only

one way. If the plug does not fit fully in the outlet, reverse

the plug. If it still does not fit contact a qualified electrician.

Never use with an extension cord unless plug can be fully

inserted. Do not attempt to defeat this safety feature.

ET1212

7400 Linder Ave, Skokie, 160077IL

800.969.3347

www.generationlighting.com

The "Generation Lighting" graphic is a registered trademark of

Generation Lighting. Generation Lighting reserves the right to

change specifications for product improvements without notification.

SAVETHESE INSTRUCTIONS!

PAGE 1
ET1212 Installation Instructions for Hopton Floor Lamp ET1212 1.0 IMPORTANT SAFETY INSTRUCTIONS This portable lamp has a polarized plug (one blade is wider than the other) as a safety feature to reduce the risk of electric shock.This plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit contact a qualified electrician. Never use with an extension cord unless plug can be fully inserted.
PAGE 2
Install the Fixture 1A 3 LAMP 2 CANDLE TUBE SOCKET LEG BASE 1 SCREW 1 Install the leg to the base by inserting it into the base and securing it in place using two screws. Repeat for remaining legs. 2 Install the candle tubes by sliding them over the sockets. 3 Screw the lamps into the sockets. Refer to the label on the lamp socket for Max Wattage information.