Installation Sheet

1
Installation Instructions for
Dunne Pendant
1.0
EP1114
Pendant
EP1114
GP I :ENERAL RODUCT NFORMATION
These fixtures are intended to be installed utilizing NEC compliant junction
boxes.
This product is safety listed for damp locations.
Incandescent lamps may be dimmed with a standard incandescent dimmer.
LED lamps may be dimmed with a LED dimmer. Consult lamp manufacturer
for additional information.
This instruction shows a typical installation.
1
2
1A
3
CAUTION RISK OF FIRE-
This product must be installed in accordance with the
applicable installation code by a person familiar with the
construction and operation of the product and the hazards
involved.
Use minimum 90°c supply conductors.
Secure the mounting plate to the junction box.
Feed the cord through the shade until the shade rests properly on the socket assembly.
Determine the wanted height of the fixture by feeding the cord through the canopy and moving the cord up or down. Place the
cord in between the two cord clips and secure it in place using the clip screws.
Trim the cord leaving enough for electrical connections. From the end of the cord, strip the insulation 4” and then strip the end of
the wires. Make sure not to nick the inner wires.Note:
Connect the fixture to a suitable ground in accordance to local electrical codes.
Connect the white fixture wire (square and/or rigid) to the neutral power line wire with a wire nut.
Connect the black fixture wire (round and/or smooth) to the hot power line wire with a wire nut.
Neatly place all the wires into the junction box, place the canopy onto the mounting studs, and secure it in place by screwing the
cap nuts onto the studs.
Screw the lamps into the sockets. Refer to the label on the socket for Max Wattage Information.
5
6
7
8
9
CAP NUT
MOUNTING PLATE
CANOPY
MOUNTING STUD
9
8
LAMP
CORD
CORD CLIP
CLIP SCREW
3
4
CORD
7
JUNCTION BOX
6
8
SOCKET ASSEMBLY
2
4