Installation Guide

2
1
2
1A
3
4
5
6
7
8
9
10
Install the Fixture
If necessary, screw the short end of the threaded nipple tightly onto the mounting plate, then screw the screw collar and canopy loop
onto the threaded nipple.
Secure the mounting plate to the junction box.
Determine the wanted height of the fixture and remove a portion of the chain from the bottom by opening a link with pliers.
Feed the cord through the spacer and fixture loop, then screw the fixture loop onto the fixture.
Install the large quick link to bottom end of the chain, then secure the large quick link onto the fixture loop.
Unscrew the collar nut from the screw collar, then install the collar nut and the canopy onto the chain (in that order).
Install the small quick link onto the remaining end of the chain, then secure the small quick link onto the canopy loop.
Weave the cord through the chain, canopy loop, and canopy, threaded nipple, and out of the junction box. Trim the cord leaving
enough to make electrical connections.
Connect the fixture to a suitable ground in accordance to local electrical codes.
Connect the white fixture wire (square and/or rigid) to the neutral power line wire with a wire nut.
Connect the black fixture wire (round and/or smooth) to the hot power line wire with a wire nut.
Neatly place all the wires into the junction box, place the canopy onto the mounting plate, and secure it in place by screwing the collar
nut tightly onto the screw collar.
Screw the lamp into the socket. Refer to the label on the lamp socket for Max Wattage information.
11
12
13
11
10
MOUNTING PLATE
JUNCTION BOX
THREADED NIPPLE
LAMP
COLLAR NUT
CHAIN
SMALL QUICK LINK
FIXTURE LOOP
SPACER
FIXTURE
CANOPY
5
4
7
13
SCREW COLLAR
LARGE QUICK LINK
3
CANOPY LOOP