Installation Guide

2
1A
Install the Fixture
1
2
3
4
5
6
7
8
If necessary, screw the short end of the threaded nipple tightly onto the mounting plate.
Install the shade to the socket assembly and secure it in place using the shade screws.
Screw the lamp into the socket. Refer to the label on the socket for Max Wattage Information.
Determine the wanted height or look of the fixture with the provided stems and pivot, then assemble them by screwing them
together.
Feed the fixture wires through the column, then screw it onto the socket assembly.
Feed the fixture wires through the stem assembly and screw it onto the column.
Unscrew the collar nut off the screw collar and place it onto the stem followed by the canopy.
Screw the screw collar onto the threaded nipple.
Feed the fixture wires through the threaded nipple and screw the mounting plate assembly onto the stem assembly.
Align and secure the mounting plate to the junction box.
Connect the fixture to a suitable ground in accordance to local electrical codes.
Connect the white fixture wire (square and/or rigid) to the neutral power line wire with a wire nut.
Connect the black fixture wire (round and/or smooth) to the hot power line wire with a wire nut.
Neatly place all the wires into the junction box, place the canopy onto the mounting plate, and secure it in place by screwing the
collar nut tightly onto the screw collar.
9
10
11
12
13
13
12
MOUNTING PLATE
JUNCTION BOX
COLUMN
STEM ASSEMBLY
3
CANOPY
SCREW COLLAR
SHADE
5
SHADE SCREW
SOCKET ASSEMBLY
LAMP
THREADED NIPPLE
PIVOT
COLLAR NUT
14
2 2
6