Manualshelf

Installation Guide

ManualsBrandsGeneration Lighting ManualsChandeliersCarlow 6 Light 48" Wide Taper Candle Chandelier
12
Temporarily install the mounting to the junction box and mark the anchor locations through the holes on the mounting plate.
Remove the mounting plate, drill appropriate sized holes at the marked locations and install the anchors.
Secure the mounting plate to the junction box and screw the anchor screws into the anchors.
Feed the fixture wires through the stems, then screw the stems onto the socket assembly.
Feed the fixture wires through the plate, upper frame, washers, and fixture loops, then secure them to the stems by screwing on the fixture
loops.
Place the center frame on top of the lower frame, then lower the upper frame onto the center frame and secure them together using the frame
washers and screws as shown. NOTE: This step will require the help of another person.
Install the candle tubes by sliding them over the sockets.
Screw the lamps into the sockets. Refer to the label on the lamp socket for Max Wattage Information.
Determine the wanted height of the fixture and remove a portion of the chain from the bottom by opening a link with pliers.
Install the large quick link to bottom end of the chain, then secure the large quick link onto the fixture loop.
Install the small quick link onto the remaining end of the chain, then secure the small quick link onto the canopy loop.
Weave the cord through the chains, canopy loops, and canopy, and out of the junction box. Trim the cord leaving enough to make electrical
connections.
Connect the fixture to a suitable ground in accordance to local electrical codes.
Connect the white fixture wire (square and/or rigid) to the neutral power line wire with a wire nut.
Connect the black fixture wire (round and/or smooth) to the hot power line wire with a wire nut.
Neatly place all the wires into the junction box, place the canopy onto the mounting plate, and secure it in place by using the fixture screws.
1
2
1A
3
4
5
6
7
8
9
10
11
12
Install the Fixture
2
13
14
15
SMALL LINK
CANOPY LOOP
ANCHOR
15
JUNCTION BOX
PLATE
CANOPY
14
CHAIN
FIXTURE SCREW
WASHER
MOUNTING PLATE
4
FIXTURE LOOP
SOCKET ASSEMBLY
7
CENTER FRAME
LAMP
SOCKET
CANDLE TUBE
6
8
ANCHOR SCREW
LARGE LINK
STEM
UPPER FRAME
LOWER FRAME
FRAME SCREW
6
5
4
5
16
10 10
11 11
2
3
FRAME WASHER