Installation Guide

If necessary, screw the short end of the threaded nipple tightly onto the mounting plate, then screw the screw collar and canopy loop onto
the threaded nipple.
Secure the mounting plate to the junction box.
Install the candle tubes by sliding them over the sockets.
Screw the lamps into the sockets. Refer to the label on the lamp socket for Max Wattage Information.
Determine the wanted height of the fixture and remove a portion of the chain from the bottom by opening a link with pliers.
Install the large quick link to bottom end of the chain, then secure the large quick link onto the fixture loop.
Unscrew the collar nut from the screw collar, then install the collar nut and the canopy onto the chain (in that order).
Install the small quick link onto the remaining end of the chain, then secure the small quick link onto the canopy loop.
Weave the cord through the chain, collar nut, canopy, canopy loop, and threaded nipple, and out of the junction box. Trim the cord leaving
enough to make electrical connections.
Connect the fixture to a suitable ground in accordance to local electrical codes.
Connect the white fixture wire (square and/or rigid) to the neutral power line wire with a wire nut.
Connect the black fixture wire (round and/or smooth) to the hot power line wire with a wire nut.
Neatly place all the wires into the junction box, place the canopy onto the mounting plate, and secure it in place by screwing the collar nut
tightly onto the screw collar.
1
2
1A
3
4
5
6
7
8
9
10
11
12
Install the Fixture
2
13
CHAIN
CANOPY LOOP
MOUNTING PLATE
12
LARGE
QUICK LINK
JUNCTION BOX
SMALL QUICK LINK
CANOPY
11
COLLAR NUT
SCREW COLLAR
THREADED NIPPLE
8
4
LAMP
SOCKET
CANDLE
TUBE
6
FRAME
3
FIXTURE LOOP