Installation Guide

2
Secure the mounting plate to the junction box.
Feed the fixture wires through the shade, shade ring, and knurled nut in that order, then secure them together by screwing the
knurled nut onto the socket assembly nipple.
Feed the fixture wires through the fixture base and screw it onto the socket assembly nipple.
Connect the fixture to a suitable ground in accordance with local electrical codes.
Connect the white fixture wire to the neutral power line wire with a wire nut.
Connect the black fixture wire to the hot power line wire with a wire nut.
Neatly tuck the wiring into the junction box, place the fixture base onto the mounting studs, and secure it in place by screwing
the cap nuts onto the studs.
Screw the lamps into the sockets. Refer to the label on the socket for max wattage information.
Place the diffuser, cap, and washer onto the lower socket assembly nipple, then secure them in place by screwing the hex nut
onto the nipple.
Place the cup onto the lower socket assembly nipple and secure it in place by screwing the desired finial onto the nipple.
1
2
3
1A
4
5
6
Install the Fixture
7
SHADE RING
MOUNTING PLATE
FIXTURE BASE
SHADE
5
4
JUNCTION BOX
CAP NUT
LAMP
8
3
DIFFUSER
SOCKET ASSEMBLY
KNURLED NUT
MOUNTING STUD
CAP
HEX NUT
FINIAL
FINIAL
CUP
WASHER
8
9
10
9
10
7 7