Manualshelf

Installation Sheet

ManualsBrandsGeneration Lighting ManualsAH by Alexa HamptonGeneration Lighting Helios 3 Light 17" Wide Semi-Flush Ceiling Fixture
12
1
Installation Instructions for
If necessary, screw the shorter end of the threaded nipple tightly onto the mounting plate.
Fasten the screw collar into the bottom end of the threaded nipple and lock into position by tightening the hex nut.
Screw the lamps into the sockets. Refer to the label on the lamp socket for Max Wattage Information
Place the fixture onto the bottom of the socket assembly, then place the tooth washer onto the nipple and secure it in place using
the hex nut.
Screw the cover onto the bottom of the socket assembly nipple.
Feed the fixture wires through the collar nut and canopy, then slide them down the socket assembly pipe.
Feed the fixture wires through the screw collar assembly, then screw it onto the pipe.
Pull the fixture and power line wires out of the junction box, then secure the mounting plate to the junction box.
Connect the fixture to a suitable ground in accordance to local electrical codes.
Connect the white fixture wire to the neutral power line wire with a wire nut.
Connect the black fixture wire to the hot power line wire with a wire nut.
Neatly place all the wires into the junction box, place the canopy onto the threaded nipple, and secure it in place by screwing the
collar nut onto the screw collar.
1
2
1A
3
4
1
6
7
8
5
Helios Semi-Flush Mount
1.0
AF1083
AF1083
Ceiling
GP I :ENERAL RODUCT NFORMATION
These fixtures are intended to be installed utilizing NEC compliant junction
boxes.
This product is safety listed for damp locations.
Incandescent lamps may be dimmed with a standard incandescent dimmer.
LED lamps may be dimmed with a LED dimmer. Consult lamp manufacturer
for additional information.
This instruction shows a typical installation.
CAUTION RISK OF FIRE-
This product must be installed in accordance with the
applicable installation code by a person familiar with the
construction and operation of the product and the hazards
involved.
Use minimum 90°c supply conductors.
9
10
11
MOUNTING PLATE
COLLAR NUT
11
10
JUNCTION BOX
THREADED NIPPLE
FIXTURE
LAMP
SOCKET ASSEMBLY
CANOPY
SCREW COLLAR
3
4
TOOTH WASHER
HEX NUT
COVER
NIPPLE
12

Summary of content (2 pages)