Installation Sheet

1
Installation Instructions for
If necessary, screw the shorter end of the threaded nipple tightly onto the mounting plate.
Secure the mounting plate to the junction box.
Screw the lamps into the sockets. Refer to the label on the lamp socket for Max Wattage Information.
Insert the glass into the fixture frame, place the bottom frame on the upper frame, and secure the bottom frame to the fixture frame
using the frame screws.
Connect the fixture to a suitable ground in accordance to local electrical codes.
Connect the white fixture wire to the neutral power line wire with a wire nut.
Connect the black fixture wire to the hot power line wire with a wire nut.
Place the fixture base onto the threaded nipple, then secure them in place by screwing the threaded pipe onto the nipple.
Place the ring, diffuser, and washer onto the threaded pipe, then secure them in place by screwing the hex nut onto the pipe. Do not
over-tighten.
Place the cup onto the threaded pipe and secure it in place by screwing the finial onto the pipe. Do not over-tighten.
1
2
1A
3
4
1
6
7
8
5
9
Alec Flush Mount
1.0
AF1072
AF1072
Ceiling
GP I :ENERAL RODUCT NFORMATION
These fixtures are intended to be installed utilizing NEC compliant junction
boxes.
This product is safety listed for damp locations.
Incandescent lamps may be dimmed with a standard incandescent dimmer.
LED lamps may be dimmed with a LED dimmer. Consult lamp manufacturer
for additional information.
This instruction shows a typical installation.
CAUTION RISK OF FIRE-
This product must be installed in accordance with the
applicable installation code by a person familiar with the
construction and operation of the product and the hazards
involved.
Use minimum 90°c supply conductors.
MOUNTING PLATE
FIXTURE BASE
7
6
JUNCTION BOX
THREADED NIPPLE
8
DIFFUSER
THREADED PIPE
RING
FINIAL
CUP
10
WASHER
HEX NUT
GLASS
4
FRAME COVER
FRAME SCREW
10