Installation Sheet

1
Installation Instructions for
Secure the mounting plate to the junction box.
Connect the fixture to a suitable ground in accordance to local electrical codes.
Connect the white fixture wire to the neutral power line wire with a wire nut.
Connect the black fixture wire to the hot power line wire with a wire nut.
Properly place all wire nut connection into the junction box/fixture base. Align the fixture base with the mounting studs
and secure the fixture base with the cap nuts.
Screw the lamps into the sockets. Refer to the label on the lamp socket for Max Wattage information.
Place the diffuser into the fixture frame.
Lift the frame to the fixture base and align the tabs with the holes in the fixture base.
Secure the fixture frame to the base with the provided thumb screws.
1
2
1A
3
1
Transom Flush Mount
1.0
AF1063
AF1063
4
Ceiling
GP I :ENERAL RODUCT NFORMATION
These fixtures are intended to be installed utilizing NEC compliant junction
boxes.
This product is safety listed for damp locations.
Incandescent lamps may be dimmed with a standard incandescent dimmer.
LED lamps may be dimmed with a LED dimmer. Consult lamp manufacturer
for additional information.
This instruction shows a typical installation.
CAUTION RISK OF FIRE-
This product must be installed in accordance with the
applicable installation code by a person familiar with the
construction and operation of the product and the hazards
involved.
Use minimum 90°c supply conductors.
3
4
1
6
7
5
8
9
5
6 6
7
9
8
DIFFUSER
FIXTURE FRAME
THUMB NUT
MOUNTING PLATE
FIXTURE BASE
MOUNTING STUD
SOCKET
LAMP
CAP NUT
JUNCTION BOX