Instructions / Assembly

WARNING: Be sure the electricity to the system you are working
on is turned off; either the fuse removed or the circuit breaker
set at off.
FOR YOUR SAFETY
PATENT PENDING
*NOTE: When parallel wire is used, the tracer wire is square shaped
or ridged, and the less tracer wire is round in shape or smooth. (Seen
best when viewed from wire end.) To separate wires, grasp the ends
of each wire and pull apart.
2. Make a clean cut on the fixture wires. Make sure no
copper strands protrude from the insulation.
3. Split ends of wire about 1 inch (See figure 2). Press wire ends
down completely into slots [A] and contacts [B] of housing half
with wire slots [C], using the flat portion of a screwdriver.
4. Align housing half with holes [D] to other housing half [C]. Snap
housings together, use pliers if necessary.
5. Cut ground wires making sure they are long enough to be flush
with opposite ends of housing.
6. Insert both ground wires through holes (as shown in fig. 3).
7. Press ground contact [E] into housing [D], use pliers if necessary,
until ground contact [E] is flush with housing [D].
1. Check wires for identification marks. See Fig.1 Be sure to keep
polarity consistent.
TRACER WIRE
HOUSING HALF
WITH HOLES (D)
CONTACTS (B)
GROUND WIRE
GROUND WIRE
FIXTURE
WIRES
SLOTS (A)
HOLES
GROUND
CONTACT (E)
HOUSING HALF WITH WIRE SLOTS (C)
NON TRACER
WIRE
FIGURE 2
FIGURE 3
MAX. WATTAGE THROUGH SPLICER/EXTENDER IS 840 WATTS
AT 12O VOLTS
W
ARNING: Only install the splicer while fixture is on the ground.
NOTE: Be sure the fixture wires loop loosly around the fixture chain,
and fixture is suspended
by the fixture chain and not hanging by the
fixture wire!
GROUP A: CONNECT
TO BLACK HOUSE WIRE
GROUP A: CONNECT
TO WHITE HOUSE WIRE
BLACK
WHITE
*PARALLEL WIRE (ROUND & SMOOTH)
*PARALLEL WIRE (SQUARE & RIDGED)
WHITE OR GREY WITH TRACER
WHITE OR GREY WITHOUT TRACER
BROWN, GOLD OR BLACK WITHOUT TRACER BROWN, GOLD OR BLACK WITH TRACER
FIGURE 1
INSTALLATION AND SAFETY INSTRUCTIONS 110596 HC-281
HC-281 CONTINUED 110596
O.K.!
NO!
THE TWO HALVES
ARE INSTALLED
PROPERLY. THEY ARE
FLUSH WITH EACH
OTHER.
THE TWO HALVES
ARE NOT
INSTALLED
PROPERLY. THEY ARE
NOT
FLUSH WITH
EACH OTHER.
USE PLIERS IF NECESSARY TO PRESS
THE TWO HALVES TOGETHER.