Instructions / Assembly

INSTALLATION AND SAFETY INSTRUCTIONS
FOR YOUR SAFETY
ASSEMBLY
GENERAL
WARNING: BE SURE THE ELECTRICITY TO THE WIRES YOU
ARE WORKING ON IS SHUT OFF. EITHER THE FUSE REMOVED
OR THE CIRCUIT BREAKER OFF .
You don’t need special tools to install this fixture. Be sure to follow the
steps in the order given. Under no circumstances should a fixture be
hung on house electrical wires, nor should a swag type fixture be
installed on a ceiling which contains a radiant type heating system.
Read instructions carefully. If you are unclear as to how to proceed,
consult a qualified electrician.
Carefully remove the fixture from the carton and check that all parts
are included, as shown in Figure 1 & 2. Be careful not to misplace
any of the screws or parts which are needed to install this fixture.
GREEN
GROUNDING SCREW (R)
*OUTLET BOX
SCREWS
MOUNTING
BAR (A)
*WIRE
CONNECTORS
MOUNTING
SCREWS (I)
*GROUND WIRE
*OUTLET BOX
GROUNDING AND MOUNTING BAR LOCK UP
FIGURE 2
*NOT INCLUDED
FIGURE 1
*NOT SUPPLIED
*OUTLET
BOX
FIXTURE
MOUNTING
SCREWS (I)
*WIRE
CONNECTORS
MOUNTING
BAR (A)
*OUTLET
BOX SCREWS
IF SUPPLY WIRES ARE LOCATED WITHIN 3” OF
BALLAST, USE WIRE RATED FOR AT LEAST 90˚C.
WARNING: FOR FIXTURES PROVIDED WITH 75˚ C
OR 90˚ C SUPPLY WIRE WARNING ONLY (THESE
WARNINGS ARE PROVIDED ON THE U.L. LABEL
AND ON THE FIXTURE CARTON).
WARNING: RISK OF FIRE. MOST DWELLINGS
BUILT BEFORE 1985 HAVE SUPPLY WIRE RATED
60˚ C. CONSULT A QUALIFIED ELECTRICIAN
BEFORE INSTALLING.
CANOPY (D)
RETAINING
SCREWS (O)
CAGE BRACKETS
DIFFUSER
Installation And
Safety Instruction
HC-533
040301
Line art shown may not exactly match the fixture enclosed.
However, the installation instructions do apply to this fixture.
Fill In Item Number On Carton And
File This Sheet For Fixture Reference. ITEM#_______________