Installation Guide

1A
Install the Fixture
2
Secure the mounting plate to the junction box.
Connect the fixture to a suitable ground in accordance to local electrical codes.
Connect the white fixture wire (square and/or rigid) to the neutral power line wire with a wire nut.
Connect the black fixture wire (round and/or smooth) to the hot power line wire with a wire nut.
Neatly place all the wires into the junction box, place the canopy onto the mounting studs, and secure it in place by screwing the cap nuts
onto the studs.
Screw the lamps into the sockets. Refer to the label on the socket for Max Wattage Information.
Screw the threaded pipe into the bottom of the socket assembly. Then screw one of the hex nuts to the bottom of the center
rod.
Place two washers onto the threaded pipe and slide the shade over the center rod and secure in place with two more washers
and the other hex nut.
Place the lower cap on to the threaded pipe and secure in place with the finial.
1
2
3
4
5
6
7
8
9
JUNCTION BOX
MOUNTING PLATE
FIXTURE BASE
6
MOUNTING STUD
CAP NUT
4
3
5
LAMP
SOCKET ASSEMBLY
SHADE
FINIAL
LOWER CAP
WASHER
HEX NUT
WASHER
HEX NUT
WASHER
WASHER
SOCKET ASSEMBLY
THREADED PIPE
9
7
8
1