Installation Guide

Secure the mounting plate to the junction box.

Connect the fixture to a suitable ground in accordance to local electrical codes.

Connect the white fixture wire to the neutral power line wire with a wire nut.

Connect the black fixture wire to the hot power line wire with a wire nut.

Place the fixture base onto the mounting plate studs and secure it in place by screwing the cap nuts onto the mounting

plate studs.

Screw the lamps into the sockets. Refer to the label on the socket for Max Wattage Information.

Install a hex nut onto each end of the threaded pipe, then screw the threaded pipe to the bottom of the socket assembly.

Place a steel washer, rubber washer, the shade, rubber washer, and steel washer (in that order) onto the threaded pipe,

then secure them in place by screwing a hex nut onto the threaded pipe.

Place the cup onto the threaded pipe and secure it by screwing the finial onto the threaded pipe.

FIXTURE BASE

Install the Fixture

JUNCTION BOX

MOUNTING PLATE STUD

MOUNTING PLATE

CAP NUT

SHADE

SOCKET ASSEMBLY

HEX NUT

FINIAL

CUP

THREADED PIPE

RUBBER WASHER

STEEL WASHER

RUBBER WASHER