Installation Guide

1A
Install the Fixture
2
Secure the mounting plate to the junction box.
Connect the fixture to a suitable ground in accordance to local electrical codes.
Connect the white fixture wire (square and/or rigid) to the neutral power line wire with a wire nut.
Connect the black fixture wire (round and/or smooth) to the hot power line wire with a wire nut.
Neatly place all the wires into the junction box, place the canopy onto the mounting studs, and secure it in place by screwing the cap nuts
onto the studs.
Screw the lamp into the socket. Refer to the label on the socket for Max Wattage Information.
Place two washers onto the threaded pipe and slide the shade over the center rod and secure in place with two more washers
and the other hex nut.
Carefully install the glass balls making sure to avoid making friction with the other glass balls. Screw the glass ball onto the ends of
the arms until snug. Make sure the glass ball is installed correctly before releasing. Repeat for remaining glass balls.
1
2
3
4
5
6
7
8
JUNCTION BOX
MOUNTING PLATE
FIXTURE BASE
8
MOUNTING STUD
CAP NUT
4
3
5
LAMP
GLASS
BALL
SOCKET
ARM
1