Installation Sheet

2
1A
Level and center the backplate over the junction box, then mark the anchor holes locations through the holes on the mounting
plate.
Drill appropriate sized holes at the marked locations.
Connect the fixture to a suitable ground in accordance with local electrical codes.
Connect the white fixture wire to the neutral power line wire with a wire nut.
Connect the black fixture wire to the hot power line wire with a wire nut.
Secure the backplate to the ceiling using the mounting screws.
Install the anchors at the marked locations through the mounting plate.
Install the diffuser to the backplate by carefully inserting it into the backplate until it snap into place. Make sure the diffuser
is fully secured before releasing.
1
2
3
4
5
6
7
88
ANCHOR
5
4
BACKPLATE
JUNCTION BOX
MOUNTING
SCREW
DIFFUSER
3
6
6
7
7
8
Install the Fixture