Use and Care Manual

GEM110 Mixer operation instruction edition a
in clockwise direction.
③ Starting procedure: Pull the gear change hand lever 1 to position 1
before staring, Safe hood is in closed state. Then
turn on the power
switch 5, after the mixer is in normal operation ,set the speed required.
④
Speed transformation: If you want to change the speed, p
lease pull
the bent lever 6 to the lowest point ,after pull the gear change hand lever
1 to the p
osition required, then pull the bent lever 6
to the highest point
and lift the support 7 to the highest
position. The ma
chine can be in
norm
al operation at this tim
e.
⑤ Installation procedures for meat Mincer head : stop operation
first ,loose stud bolt and lift the top cover of its he
ad. Then put on th
e
min
cer and tighten the stud bolt.1
st
speed should be used for mincing
meat.
⑥Shutting down: When the operation is comp
leted, turn off the power
switch 5 fi
rst, then pull the gear change hand lever 1 to position 1
, and
pull back the hand lever 6 to the lowest point and finally disconnect
power supply.
5、Accessories and Functions
① Spherical mixer: Used for stirring of liquid materials, such as cream
and egg.
② Plate m
ixer: Used for stirring of paste, powder,
and fragmental
materials, such as stuffing.
③ Hook m
ixer: Used for stirring of mo
re sticky materials, such as
dough .
6、Notes
① The power socket must be provided with a good ground wire to
guarantee the mixer’s good grounding through it. There will be a electric
shock if no ground wire or an improper grounding mounted. The ground
wire can n
ever be connected with gas pipe, water pipe, lightni
ng rod or
telephone line. Electric leakage should be checked after installation.
② Don’t put your hand into the stirring barrel during operation. Power
supply should be disconnected before the mixer is going to be installed.
③
Don’t operate the mixer beyond the time limit to prevent
reduction
of its service life.
④
The mixer should be mounted on a st
able and clean place. Keep it
away from overheated or overwet pl
aces and away from equipm
ent
which has strong electrom
agnet or can produce strong electroma
gnet.
⑤
Keep the machine clea
n constantly. Disconnect power supply before
Page 3 of 3