User Manual

3
SPECIFICATIONS
Length of Twin Probes 5 in. (127mm)
Diameter of Probes 0.14 in. (3.6mm)
Probe Hardness 60 HRC (Hardness Rockwell “C” scale)
Probe Covering Heat shrink tubing
Probe Tips Rounded and replaceable (screw-in)
Length of Probe Cable 56 in. (1.4m)
WARRANTY INFORMATION
General Tools & Instruments’ (General’s) MP905 Deep Wall Moisture
Probe for General's MMD900, MMD950 or MMD950W is warranted to
the original purchaser to be free from defects in material and
workmanship for a period of one year. Subject to certain restrictions,
General will repair or replace this instrument if, after examination, the
company determines it to be defective in material or workmanship.
The warranty period begins on the date of purchase. You are
encouraged to register your product online. General will extend
your warranty an additional 60 days if you register at
www.generaltools.com/ProductRegistry.
This limited warranty does not apply to damages that General
determines to be from an attempted repair by non-authorized
personnel or misuse, alterations, normal wear and tear, or
accidental damage. The defective unit must be returned to General
Tools & Instruments or to a General-authorized service center,
freight prepaid and insured.
Acceptance of the exclusive repair and replacement remedies
described herein is a condition of the contract for purchase of this
product. In no event shall General be liable for any incidental,
special, consequential or punitive damages, or for any cost,
attorneys’ fees, expenses, or losses alleged to be a consequence of
any damage due to failure of, or defect in any product including,
but not limited to, any claims for loss of profits.