User's Manual

LCD Screen Illustration
A：Low battery indication
B：Measuring result
C：Wood mode indication
D：Data hold indication
E：Building material mode indication
F: Bluetooth connection indicators
Operation Notes
● Install battery
Remove the battery lid on the end of the unit, place one 9V block battery（6F22 or 6LR61） according to the
correct sign marked in the compartment, then put back the lid.
● Measure moisture
1、Pull out the protection cover, remove the protection from the pins;
2、Press the power key, LCD will display“”__ __ __”, The default measuring mode is for wood,selecte the mode
by mode switching key.
3、Insert the two detection pins into target material;
4、Under wood mode, reading of the target wood is displayed on LCD screen, available range is 5%～50%.
When lower than 5%, the screen shows “__ __ __”;When higher than 50%, the screen shows “￣ ￣ ￣”.
5、Under building material mode, reading of the target material is displayed on LCD screen, available range is
1.5%～33%. When it is lower than 1.5%, the screen shows” __ __ __”, when it is higher than 33%, the screen
shows “￣ ￣ ￣”.
6、During measuring, press the trigger，the symbol “HOLD” will display and hold the data, press again to make
“HOLD” disappear and exit data hold.
7、During operation, each press with buzzer sound indication, when the moisture reading too high ( under wood,