Operating Guide

CHECKING BATTERY VOLTAGE



Warning



To avoid possible electrical shock or damage to the meter, do not apply a

voltage greater than 600V between the meter’s and

COM jacks.

(1) Turn the rotary switch to the 9V or 1.5V position, corresponding to the

nominal voltage of the battery to be tested.

(2) Plug the black test lead into the COM jack and the red test lead into the

jack.

(3) Touch the red test lead to the battery’s anode (+ terminal) and the black test

lead to its cathode (– terminal). The battery’s voltage will appear on the

display.

USING THE NCV DETECTOR

To check whether a line, cable or AC outlet is “hot”

(energized), touch it with

the top of the meter or bring the top within 1/4 inch of it after moving the rotary

function switch to the NCV position. If the beeper sounds repeatedly and the

red LED at the top of the meter (Fig. 1, Callout 10) flashes rapidly, the line or

outlet is carrying at least 110VAC

RMS

USING THE DMM WTH THE ToolSmart

™

APP AND

AN APPLE iOS OR ANDROID SMARTPHONE

To stream measurements and calculations made by the DMM to an Apple iOS

or Android smartphone, begin by downloading the ToolSmart

™

app from the

iTunes Store or Google Play Store to your mobile device.

Once you have downloaded the app, install it. Then, pair the DMM and your

phone by activating Bluetooth on your phone and pressing the button on the

DMM.

A tutorial on the app explains how to save DMM measurements to your phone

and overlay them on photos of your project taken by the phone’s camera.

TEMP

mAµAVΩ

TEMP

mAµAVΩ