Operating Guide

MEASURING RESISTANCE



Warning



To avoid electrical shock or damage to the meter when measuring resistance,

turn off all power to the circuit and discharge all high-voltage capacitors.

(1) Turn the rotary switch to the position and press the FUNC button until

, k

or M

appears on the right side of the LCD.

(2) Plug the black test lead into the front-panel COM jack and the red test lead

into the jack.

(3) Measure the resistance by touching the test leads to the desired test points

of the circuit or to the terminals of a component, as shown below.

(4) Read the measured resistance on the display. If you are working in Manual

Ranging mode and the readout is .OL, the resistance value is beyond the

currently selected range. If that is the case, use the FUNC button to select

the next-widest position.

MEASURING TEMPERATURE

The DMM includes a “K” type bead thermocouple probe for measuring surface

temperatures. To use it,

(1) Insert the +V plug of the plug adapter to which the thermocouple is

attached into the jack.

(2) Insert the COM plug of the plug adapter into the COM jack of the DMM.

(3) Turn the rotary switch to the TEMP position.

(4) Press the FUNC button until your preferred temperature measurement

unit—ºF or ºC—appears on the right side of the LCD.

(5) Attach the bead probe to the surface whose temperature you wish to

measure. The reading will be shown on the LCD.

TEMP

mAµAVΩ

TEMP

mAµAVΩ

RED TEST LEAD

BLACK TEST LEAD