User's Manual

5 V0.2 131015
●Connect the grip unit to camera probe
The inspecting grip must be connected to the camera probe. To connect the probe, make sure the keyed
ends are properly aligned. (Fig7). Once they are aligned, finger tighten the nut.
Note: The probe can’t be connected after the unit is on. Before connecting the probe, be sure the unit
is off, in case of the current harms the unit.
●Accessories installation
The unit uses accessories for 9mm probe shown in Fig.2. Accessories and camera head are connected
using thread connection. Put on the screw thread protector when no accessory is installed to avoid damage to
the thread in daily use.
Remove the thread protector before install any accessories, then put on the accessory.
● Connect the grip to screen
The product can work both the grip detach from screen and the grip attach to screen; Slide the bottom
of slot at the back screen into the slot of grip downward until you hear the locking sound, which means
connection is finished (see Fig.8). Push the screen to the upper direction until slide away the lock buckler
to detach the screen.
● Install Micro SD card (Optional Accessory)
Photos and video clips will be stored in internal memory when a Micro SD card is not inserted and
detected, and icon will be displayed on LCD screen. Icon will be displayed when a Micro
SD card is detected, recorded photos and video clips will be stored in the Micro SD card instead of
internal memory.