User's Manual

12 V0.2 131015
Trouble Shootings
Problems Causes Solutions
Can’t charge.
Adapter didn’t connect well
with the product.
Please check and try again.
The connect or or cable is
broken.
Replace and try again.
The working temperature of
battery is so high (indication
is when plug in the adapter,
the red and green LED on at
the same time) .
Charge after the temperature is down.
The screen is on but
without image or shows
“No Signal”
1、the grip power is off Check and open the grip power
2、The probe is loosed. Check and connect again.
3、Stains on the camera head.
Check if exists stains
The product couldn’t
power on.
The circuit is in protection
status.
Use adapter for charging to release.
Low energy of inside battery Use adapter for charging
Dead battery Ask a technician to replace the battery.
Unusual display or invalid
keys
Interference to the screen or
voltage fluctuation.
Please use the reposition key on the
back of screen
C a u t i o n s
● Don’t drop the product or use by force.
● Don’t disassemble the product to avoid failure.
● Don’t place the product with corrosive gas or objects.
● Don’t expose the product in vibration、high or low temperature.
● Store the product in a safe area.
● Don’t immerse the product into water, which will result in damage to product.●
Please charge the inside battery every three month if no use for long time.
Technical Specification
Name Multifunction video inspection
Model DCS500T/DCS500R
Recommended use Indoor
Standard
probe
specifications
（KC09AV4）
image sensor type
30,000 pixels CMOS image sensor
Outer diameter of
camera head
Φ9mm
Focal length 50mm
visible angle 60°
Probe length
standard flexible 1m;
2m/3m or customized (the longest length of obedient probe
is 10m and flexible probe is 40m)