User's Manual

10 V0.2 131015
inspection, automobile inspection, circuitry, vessel and aircraft inspection. While in operation, the product
is easy to extend ahead. If there is a distance limitation, the accessories could be applied to pick up rings
or screws on the floor.
● Operation Precautions:
a. Please read the safety instructions carefully, choose desirable work area for fear causing danger.
b. The probe is flexible to help you operate in hard-to–reach areas. Please don’t insert or bend by force..
Please do not over bend any part of the probe. Normally, the bending radius should more than 5cm to
prevent from causing permanent damage to the probe.
c. Don’t use the probe or camera head to modify surroundings, clear pathways or clogged areas. It
couldn’t be used as a fishing rod or tape.
d. The hand-held display unit is not waterproof .The camera head and its cover are waterproof, but not
acid-proof or fireproof. Don’t touch with these materials or they will ruin the camera head’s protective
plastic. Avoid immersing the camera head into corrosive, oily places or high-temperature objects.
e. Don’t place the inspection into anything or anywhere that may contain a live electrical charge. Please
check following methods to avoid injury.
For walls: For inspecting the inside walls, be sure to shut off the circuit breaker to the whole house
before using the tool.
For pipes: If you suspect a metal pipe could contain an electrical charge, have a qualified
electrician to check the pipe before using. A ground circuit, in some cases, can be
returned to the cast aluminum pipes and cause them to be charged.
For automobiles：Be sure the automobile is not running during inspection. Metal and liquid under
the hood may be hot. Don’t get oil or gas on the camera head.
Operation Notes
●Please read the manual thoroughly and make sure proper training has been complete before operating
this product.
●The green LED on the grip will flash when battery is low, eventually the grip power will power off
itself.
●The product can display real time battery capacity, “ ” and “Low battery” will flash when battery is
low, eventually the product will power off itself.
●Do not remove SD card during recording and USB connection mode.
●Don’t immerse the inspection into water, which will result in electric shock and damage.
●Only while the product is assembled well, the camera head is water-proof, but the grip and the screen
isn’t fully water-proof.
●Don’t use the product if white dew forms inside the camera head.