Use and Care Guide

the camera head into corrosive, oily places or high

temperature objects.

5. Don’t place the cameral head or probe into anything or

anywhere that may contain a live electrical charge.

Please check following methods to avoid injury.

For walls: For inspecting the inside walls, be sure to shut off

the circuit breaker to the whole house before

using the tool.

For pipes: If you suspect a metal pipe could contain an

electrical charge, have a qualified electrician

to check the pipe before using. A ground circuit,

in some cases, can be returned to the cast

aluminum pipes and cause them to be charged.

For automobiles: Be sure the automobile is not running during

inspection. Metal and liquid under the hood may

be hot. Don’t get oil or gas on the camera head.

• Please do not operate this product unless the manual

has been read thoroughly and proper training has been

completed.

• Do not immerse the handheld display unit in water which

will result in electric shock and damages.

• The camera head is water-proof, but the handheld display

is not water-proof.

• Do not use the product if condensation forms inside

the camera head.

• If the tool does not work well after turning it on. Please

take the batteries out and do not use. Please have the

unit checked by a qualified technician.

• Store idle products out of reach of children and other

untrained personnel. The product is dangerous in the

hands of untrained users.

• Maintain the inspection product with care. If the product

DCS200-300 MANUAL 071609 FINAL:Manual 7/16/09 1:25 PM Page 9