User Manual

SPECIFICATIONS
Camera
Imaging Sensor CMOS
Total Pixels 704 x 576 (PAL)/712 x 486 (NTSC)
Horizontal View Angle 50°
Transmission Frequency 2468MHz
Minimum Illumination 0 Lux
Modulation Type FM
Bandwidth 18MHz
Power Source 4 “AA” batteries
Unobstructed Effective Range 32.8" (10m)
Waterproof Capacity IP67 (only for probe head)
Dimensions (WxDxH) 7.3" x 5.7" x 1.6" (186 x 145 x 41mm)
(Excluding Flexible Tube)
Weight (about) 19oz (530g)
Monitor
LCD Screen Type 3.5" TFT-LCD
Effective Pixels 320 (R.G.B.) x 240
Video System PAL/NTSC
Transmission Frequency 2414MHz,2432MHz, 2450MHz,2468MHz
Exterior Supply Voltage 5VDC
Consumption Current (Max.) 500mA
Charge Time 3 hours
Work Time 2 hours
Picture/Video Pixels 640 x 480
Video Size 27M bytes/minute
Frame Rate 30 frames/second
Video Output Level 0.9 - 1.3VP-P@75ohm
Receiving Sensitivity -85dBm
Dimensions (W x D x H) 4" x 2.8" x 1" (100 x 70 x 25mm)
Weight (About) 5oz (140g)
Operating Temperature 14 to 122°F (-10 to 50°C)
Operating Humidity 15%~85%RH
* Actual transmission range may vary according to the weather,
location, interference and building construction.
* All the specifications are subject to minor change without prior
notice.
15
6
Installing the Accessories
The three accessories include a mirror, a hook and a magnet. All are
attached to the probe tip in the same way. Install as follows:
Make sure the stem is placed at the side facing from the arrow
mark, and tighten to secure the accessory in place.
Installing the Monitor for Wired Use
The product also supports wired use by connecting the monitor to
the base unit.
Connecting the Monitor to Magnetic Base Stand
The magnetic base stand allows the user to place the monitor
remotely on any metal surface for true hands-free wireless viewing.
Connect it to the monitor as shown in the following diagram: