Manual

SETTING THE CLOCK
Press the button to enter clock setting mode. You must then press the ▲ or ►
button within two seconds or the first screen below will disappear.
To set the clock
Press button, and then press ▲ or ► button
immediately to cause left digit to blink
Use ▲ or ► button to set clock
Press button or wait 10 seconds to complete clock
setting. Then exit clock setting mode
SETTING THE RECEIVER’S TRANSMISSION SPAN AND ID CODE (CHANNEL)
These parameters of the receiver are set in the same way that they were set for the
transmitter. Follow the instructions embedded in the next two figures.
Transmission span setting
20
Press SEARCH button and hold for two
seconds to enter ID code selection mode
Press SEARCH button again to enter
transmission span selection mode
Press HOLD/MAX-H button as many times
as needed to select transmission span of
2, 10, 30, 60, or 120 seconds
Press SEARCH button and hold for two
seconds to save setting and return receiver
to measuring mode
CMR35 Manual FINAL4_020911:awb 2/9/11 11:54 AM Page 20