UPM 15X Manual

Page 8 of 12
www.generalspecialtiesmfg.com
208-265-5244
Attach orange pulley to pad eye on telestrut bracket. Thread cable with quick link
connector through pulley before closing pulley hanger with 3/8” bolt and nyloc nut.
Now attach quick link to hole on left side of winch foundation (see attached Winch
Detail).
Fully tighten collar on quick link. Pull tension on cable as it comes off winch drum
and cut zip ties. Take up slack in cable by turning winch handle while still holding
tension on cable. This will prevent it from jamming in winch drum.
Wind up all the slack. Then it is safe to remove wedges and wood block.
Move the longitudinals as close as possible to horizontal to one another to begin
installing rails. 15X and 18X use channel rails and have no brackets. 12XHD uses
angle rails and brackets to attach rails to the longitudinals.