UPM 15X Manual
Page 5 of 12
www.generalspecialtiesmfg.com
208-265-5244
Assembly Instructions
UPM 12XHD, 15X, 18X
Place pivot cap on top of steel post. Orient pivot bore
with bronze bushings east and west. The 4 set bolt nuts
should face south. Secure the pivot cap with ¾” square
head set bolts.
It is essential that you bolt the winch
foundation/bracket to post approximately
1” below pivot cap. Use level to center
foundation lugs plumb with center of pivot
bore. Securely tighten bolts before
installing winch.
Bolt winch to foundation/bracket with
3 – ½” bolts. DO NOT cut plastic zip
ties holding cable yet. Install handle.