UPM 15X Manual

Page 11 of 12
www.generalspecialtiesmfg.com
208-265-5244
Asdfas
WINCH DETAIL
UPM 12X HD, 12XHD Custom,
15X, 18X
REVISION:
04.21.15
LONGITUDINAL
STEP 1
Bolt winch to winch foundation with 3 3/8” grade 8 bolts
put flat washer on each side of winch/foundation interface.
STEP 2
Attach red snatch block through “eye” in telestrut bracket.
Before closing snatch block thread ¼” cable around sheave
of pulley. Then attach quick link at end of cable to hole drilled
in winch foundation. Tighten collar with a wrench.
Be sure to thread nylon nut on closure bolt for snatch block
all the way down to end of threads.
Note: At no point should you ever disconnect the
telestrut in this system unless you have purchased a
90 tilt kit.