Installation Manual

Page 4 of 8
www.generalspecialtiesmfg.com
208-265-5244
To determine which configuration to use for your modules, measure center of hole to center of
hole on the LONG edge of module (see drawing below). These are the holes that you will use
to fasten to the slots in the rails shown. Compare this dimension to dimensions shown above
and choose the most advantageous configuration.
Note: Number of panels may vary.
UPM 6X - CUSTOM
PANEL RAIL/BRACKET
CONFIGURATIONS
Standard stock Tee socket sized
for 5" schedule 40 or 80
REVISION:
Not to Scale 06.16.14
Universal aluminum
T-Slot extrusion
panel rail or you may
have aluminum angle
with punched holes.
FLAT END
PLATE
“A” CONFIGURATION
MAX. WIDTH 36 7/8”
CENTERLINE OF
SLOT
“B” CONFIGURATION
MIN. WIDTH 36 5/8”
MAX. WIDTH 40 7/8”
“C” CONFIGURATION
MIN. WIDTH 42 7/8”
MAX. WIDTH 48 1/8”
Use these mounting holes.