Installation Guide

Page 5 of 8
www.generalspecialtiesmfg.com
208-265-5244
UPM 6X Custom for 3 Modules
Place Tee assembly on top of post. Align center tube east and west and tighten two square head set bolts to post. Finger
tighten the aluminum flat bar and straighten ½” bolts onto “Tee” endplates on the center tube. Slide crosspieces into the
flat bar arrangement. Make sure to locate the lugs on crosspieces so they are facing in toward the center tube endplates.
Place longitudinal tubes on
top of crosspieces and bolt
with square washers on top
and bottom.
Attach aluminum angle
brackets to longitudinals
with square U-bolts.
Oppose angle brackets
so they face in toward
each other. Attach
aluminum rails, aligning
the ends marked “Top”
to the same end.
When fastening panels to rails, place first panel
at end of rails marked “Top” and work down
until all panels are in place with bolts finger
tight. Cross measure array for square, check
to see that all spaces between panels are equal
(at least ¼”), then tighten all bolts with
wrench.