Installation Manual

Page 5 of 8
www.generalspecialtiesmfg.com
208-265-5244
Custom Side of Pole Mount for 1 or 2 PV Panels
(single panel mount shown here)
A. TOP CHANNEL
B. PANEL RAILS: (MAY EITHER BE ALUMINUM ANGLE WITH HOLES PUNCHED FOR
MOUNTING YOUR PANEL OR T-SLOT ALUMINUM EXTRUSIONS FOR SLIDING YOUR PANEL
MOUNTING BOLTS IN, DEPENDING ON MODEL YOU ORDERED)
C. BRACES
D. BOTTOM CHANNEL
E. TOP BRACKET
F. BOTTOM BRACKET
These instructions are for either a one panel SOP mount or a two panel SOP mount. The assembly
details are the same. Where instructions refer to a single panel, remember that if your mount
has two panels, the process is the same. Keep approximately ¼” space between panels. Also,
note that rail and brace dimensions may vary depending on the model of SOP you ordered.
A
B
C
D
E
F
E
F