Installation Guide

Page 4 of 4
www.generalspecialtiesmfg.com
208-265-5244
4. Attach cross braces. It is very important that you install the cross braces correctly so
that you are able to adjust the tilt. The picture on the left shows the mount laying flat with a
panel installed. The flat bar cross brace goes in the
center as shown. Be sure to square top to bottom.
Loosely set in brace with ¼” bolt and flange nut.
The slotted cross brace goes on top of that and then
the un-slotted cross brace goes on top of the
slotted. Attach the ¼”
x 1” bolt, washer and
flange nut. When the
mount is upright the
slotted brace needs to
look like the picture on
the right.
Tighten all bolts and set to desired tilt.
Shown below are 4 of the different adjustment angles for these mounts.
More slotted space here